The daily maintenance of the generator can extend the service life

The daily maintenance of the generator can extend the service life 16:59 Weifang generator sets Shandong generator generating units of the long-term use or prompt to use a long time to maintain the need for maintenance, in order to maintain the performance of generating units, so that the generator to maintain a good state. .........

The daily maintenance of the generator can extend the service life 16:59 Weifang generator sets Shandong generator generating units of the long-term use or prompt to use a long time to maintain the need for maintenance, in order to maintain the performance of generating units, so that the generator to maintain a good state. The following is a case, a customer's generators due to prolonged use but did not regularly do some maintenance problems, as well as the maintenance process. To do the maintenance of the generator mainly have these steps, the first maintenance is the most important before the start of the generator should be filled through the oil filling the oil. When filling the engine should be placed in a horizontal position and observe the changes in the generator oil level. Generators require multi-stage viscosity of the oil, because the multi-stage viscosity of the oil for a wide range of operating temperature and consumption rate than the single-stage viscosity of about 30% lower oil. Add oil to wait for a while to look at the oil level on the generator oil scale.

Generator schematic diagram that is equal to the oil into the oil pan after the oil level is to see the correct value. Each oil filter should be filled with cleaning oil, and then installed on the engine. The performance level of the oil represents the level of the oil additive, and the maintenance generator only selects a sufficient grade of oil to ensure reliable protection of the generator throughout the oil change cycle. Second, the maintenance of the generator should pay attention to start before filling the coolant. When filling, open the bleed valve of the upper cooling system of the engine and slowly add the coolant from the hot water tank to the engine until no air bubbles are removed from the bleed valve. Coolant should be added to the bottom of the cooling water tank to fill the neck below, not over full. Finally, the entire generator set clean, due to the long-term placement of the generator, it is easy to accumulate dust.

And diesel residue affect the normal work of the generator, so we should regularly on their style, water, etc. to clean, but also regularly boot check to ensure the normal operation of the generator.